Catalogue_RR+FT_klein

633 series US-NR15 installation height, upper row of holes mm pitch mm roller material bearing load capacity / roller kg US-NR15-075 Ident No.: 0026387 64 75 thermoplastic rubber coating ball bearings 10 US-NR15-100 Ident No.: 0026381 64 100 thermoplastic rubber coating ball bearings 10 US-NR15-125 Ident No.: 0026382 64 125 thermoplastic rubber coating ball bearings 10 US-NR15-150 Ident No.: 0026383 64 150 thermoplastic rubber coating ball bearings 10 US-NR15-175 Ident No.: 0026384 64 175 thermoplastic rubber coating ball bearings 10 US-NR15-200 Ident No.: 0026385 64 200 thermoplastic rubber coating ball bearings 10 series US-NR07 installation height, lower row of holes mm installation height, upper row of holes mm pitch mm roller material bearing load capacity / roller kg US-NR07-050 Ident No.: 0019004 54 62 50 polyamide plain bearing 40 US-NR07-075 Ident No.: 0019003 54 62 75 polyamide plain bearing 40 US-NR07-100 Ident No.: 0026935 54 62 100 polyamide plain bearing 40 US-NR07-125 Ident No.: 0026936 54 62 125 polyamide plain bearing 40 US-NR07-150 Ident No.: 0026937 54 62 150 polyamide plain bearing 40 US-NR07-175 Ident No.: 0026938 54 62 175 polyamide plain bearing 40 US-NR07-200 Ident No.: 0026939 54 62 200 polyamide plain bearing 40 Suitable castors can be found on page 226 all-purpose roller tracks // up to 40 kg per roller Installation: • standard rollers, unless otherwise specified, are mounted in the lower row of holes. Flanged rollers and rollers with thermoplastic rubber press-on bindings are always mounted in the top row of holes • middle of first roller is set 25 mm from the profile edge the track end runs all the way out • a defined initial roller gap is available at extra cost if required; please specify when ordering Screwed connection: • with special screws with plastic caps (VS26) or with steel screw (M8) When ordering, please specify the desired track type (type of roller and pitch), the desired length and the screw connection: Order example: US-NR05-050/VS26/2x1,500 The conveyed goods must rest on at least three rollers in order to ensure that they are conveyed smoothly and do not tip over. The distance or pitch between the axles refers to the distance between the center points of adjacent rollers.